Rank: Newbie
Groups: Member
Joined: 11/19/2011
Posts: 6
Points: 18
Location: North Bend (NOT Bend), OR
|
it's time to "install the 5/16 leading and trailing edge" prior to cutting sheer webs and installing sub-spars.
What, specifically is the LE and TE stock? Is it just the same 5/16 square balsa stock I've been looking at for 3 days, or is there anything special about LE/TE stock that I'm not seeing?
-Case
|
Rank: Administration
Groups: Administration
, Member
Joined: 4/9/2008
Posts: 178
Points: 379
Location: Bartlett
|
It's just 5/16" square... You should have 15 pieces of that in your Mojo 60 kit... Sorry that the "LE and TE stock" sounded misleading.
|
Rank: Newbie
Groups: Member
Joined: 11/19/2011
Posts: 6
Points: 18
Location: North Bend (NOT Bend), OR
|
New TE question:
After turning the wing and building the hatch supports, I can't find anything about sheeting the trailing edge... In the photos, it shows an UNsheeted TE (on top), and then goes right into capping the ribs and spar.
Do you sheet the TE with 2"x1/16" on the top of the wing, or is that just on the bottom?
-Case
|
